9
6. Installation
(1) The device does not have a waterproof function. After the configuration of joining the network is completed,please place it
indoors.
(2) The dust at the installation location should be wiped clean before paste the device.
1.
Remove the 3M release paper on the back of the device
and attach the device to the smooth wall (please do not stick
it to the rough wall to avoid falling off after a longtime
usage).
Note
Wipe the wall surface before installation to avoid dust on
the wall surface that affect the effect of the paste.
Do not install the device in a metal shielded box or other
electrical equipment around it to avoid affecting the
wireless transmission of the device.
1.
When installing, the device
must be installed vertically
,
as the right figure.
2.
When the tilt angle of the device in any direction changes
more than 45° (45°~180°), a tipping alarm will be issued
immediately. If the device tilts, the state will be “1”. If the
device returns to normal, the state will be “0”.
3.
When the status of the detected object does not change,
the status will be reported regularly for a certain period of
time. (The default is 1 hour that is modifiable.)
Note:
The interval of sending data can be configured by referring
the instruction document. But it is recommended that the
interval should not be too short, so as not to affect the battery
life.
The device is suitable for the following applications:
The dumping household appliances link to the protection of
powering off socket.
Various tilt sensing, such as pillars and utility poles
Angle detection, direction identification
Where it is necessary to detect whether the object is tilted
