ASSEMBLY
Assembly of telescopic rod holder with stand feet.
1.
Turn the locking level (19) from the base of the stand feet (15).
2.
Insert the lower end of the stand feet into the round base (16).
3.
Place the stand feet weight (17) under the round base and connect all
the parts with the washer (18) and the locking lever.
4.
Make sure that all the parts are connected to each other.
5.
Loosen the adjustable height knob (14) to adjust the telescopic rod
(13).
6.
Pull the telescopic rod until it stops and tighten the adjustable height
knob firmly.
ATTENTION! The adjustable height knob must be fully fastened
before starting the assembly of the motor section with the
stand.
Assembly of motor housing with telescopic rod holder.
1.
Place the motor housing (11) on the upper end of the telescopic rod
(13) and fix the motor housing to the telescopic rod with the mounting
screw (23) and the lock nut (24) and with the setting screw (21) and the
adjusting screw (20).
20. Adjusting Screw
21. Setting Screw
22. Holding Fixture
23. Lock Nut for Mounting Screw
24. Mounting Screw
