[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Plugging External Sensors
[ENG] [2PWR,v2SMS] Plugging External Sensors
–
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
sensor, which are sequentially plugged one into another. Otherwise, it can
be done independently with the help of any wire with a minimum cross section of 0,4 mm
2
. Maximum allowable
length of a flat cable is 10 m
from each sensor to a device (star topology).
Plugging IR Module
Colored Loop
Flat Loop
Contact Name
Yellow
Labeled (red) wire
SC
Green
The first wire after a labeled one
SD
Red
The second wire after a labeled one
+
Black
The third wire after a labeled one
G
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
sensor, which are sequentially plugged one into another. Otherwise, it can
be done independently with the help of any wire with a minimum cross section of 0,4 mm
2
. Maximum allowable
length of a flat cable is 10 m
from each sensor to a device (star topology).
Plugging a
A sensor is a
«dry contact», therefore the order of connecting wires is irrelevant. The number of plugged sensors is
limited only by a number of free
IO lines.
Loop
Contact Name
First wire
I1-I4
Second wire
G
The order of connecting wires is irrelevant. Depending on the output (I1-I4) on a terminal block, where a sensor is
plugged in, it is displayed on the same channel IO1-IO4 in a web interface of a device.
IO lines, to which sensors are plugged must be configured as the
«input»
in an interface of a device!
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
sensor, which are sequentially plugged one into another. Or it can be done
independently with the help of any wire with a minimum cross section of 0,4 mm
2
. Maximum allowable length of a
flat cable is 100 m.
