[ENG] NetPing 2/PWR-220 v3/ETH & NetPing 2/PWR-220 v4/SMS, User guide -[ENG] [2PWR,v2SMS] Plugging External Sensors
[ENG] [2PWR,v2SMS] Plugging External Sensors
–
Depending on ID, a temperature sensor will be displayed on a corresponding channel in a web interface of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
sensor, which are sequentially plugged one into another. Otherwise, it can
be done independently with the help of any wire with a minimum cross section of 0,4 mm
2
. Maximum allowable
length of a flat cable is 10 m
from each sensor to a device (star topology).
/
All 8 temperature sensors are plugged in parallel one to another.
Flat Loop
Contact Name
Labeled (red) wire
SC
The first wire after a labeled one
SD
The second wire after a labeled one
+
The third wire after a labeled one
G
Depending on ID, a temperature sensor will be displayed on a corresponding channel in a web interface of a device.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with
the help of
sensor, which are sequentially plugged one into another. Otherwise, it can
be done independently with the help of any wire with a minimum cross section of 0,4 mm
2
. Maximum allowable
length of a flat cable is 10 m
from each sensor to a device (star topology).
A loop of a sensor is a flat loop with a labeled first wire (red).
Colored Loop
Flat Loop
Contact Name
Yellow
Labeled (red) wire
SC
Green
The first wire after a labeled one
SD
Red
The second wire after a labeled one
+
Black
The third wire after a labeled one
G
Important! it is prohibited to plug temperature sensors with the same identification numbers (ID) to a device.
