Technical Information
Getting Started – New NetPilot Range
21
Manual configuration of LAN2 for Internet access
The manual configuration of all NetPilots interfaces is available in
Network > Connectors
section of the command interface. Once you
have accessed this screen you will need to change the setting of LAN2
connector from
Quick Configuration WAN
to
Ethernet router,
press
Edit
and progress to the network profile in the main
Connectors
screen.
In there firstly proceed to edit the
Ethernet Router Profile
, where you
have to enter your IP address for the LAN2 port and its subnet mask.
Once this is set, secondly add the
Default Route
by entering the
Gateway IP address of the routing device you are using and checking
the default route box. Confirm your settings by clicking ok when
requested as well as within the
Connectors
section itself.
If you have a
DHCP server
on your router and want the NetPilot to act
as a DHCP client select
Ethernet Cable / ADSL
as the profile for the
LAN2 connector in
Network > Connectors
and click ok till the new
setting is accepted.
If you require information on how to configure the Windows Client,
Windows Mail settings, DHCP and fixed IP addresses please refer to
documents in the Knowledge Base section within NetPilot Internet
Security’s SmartStore database under
Internet Security.net/
.
By default, the LAN1 IP Address is set to 10.0.0.1. This can be
configured to a different range.
Step by step instructions with screen shots are available in
‘How to – manual configuration’
http://smartstore.NetPilot Internet
Security.net/index.asp?297866
.