www.netmodule.com
Quick Start Guide
Safety Instructions
The NetModule Wireless Routers must be used in compliance with any and all applicable international and national laws
and in compliance with any special restrictions regulating the utilization of the communication module in prescribed ap-
plications and environments.
Use only the original accessories to prevent possible injury to health and damage to appliances and to ensure that all the
relevant provisions have been complied with. Unauthorized modifications or utilization of accessories that have not been
approved may void the warranty.
The NetModule Wireless Routers must not be opened. Only the replacement of the SIM card is permitted.
All circuits connected to the interfaces of the NetModule Wireless Routers must comply with the requirements of SELV
(Safety Extra Low Voltage) circuits and are for indoor use only. Interconnections must not leave the building nor penetrate
the body shell of a vehicle. Possible antenna circuits must be limited to overvoltage transient levels below 1500 Volts ac-
cording to IEC 60950-1, TNV-1 circuit levels using safety approved components.
Use only with certified (CSA or equivalent) power supply, which must have a limited and SELV circuit output.
The NetModule Wireless Routers are designed for indoor use. Do not expose the communication module to extreme am-
bient conditions. Protect the communication module against dust, moisture and high temperature.
We remind the users of the duty to observe the restrictions concerning the utilization of radio devices at petrol stations, in
chemical plants or in the course of blasting works in which explosives are used. Switch off the communication module
when travelling by plane.
You must proceed with increased caution when using the communication module in close proximity of personal medical
devices, such as cardiac pacemakers or hearing aids.
NetModule Wireless Routers may cause interference if it is in the proximity of TV sets, radio receivers and personal com-
puters.
After configuration it is recommended that you should create a copy or backup of the configuration settings that are
stored in the memory of the device. The configuration data can be downloaded using the Web Manager.
Do not work at the antenna installation during a lightning.
Always keep a distance bigger than 40cm from the antenna in order to reduce your exposure to electromagnetic fields be-
low the legal limits. This distance applies to Lambda/4 and Lambda/2 antennas. Bigger distances apply for antennas with
higher gain.
The NB2700 must be used with shielded Ethernet cables.
Consult the manual for the installation. Adhere to the instructions documented in the user manual.
