WGE101 Default Wireless Configuration Settings
Note:
If you are setting up a new wireless network, please set up the network and make sure it
works before adding the WGE101 Wireless Ethernet Bridge into the network.
You will need to identify the wireless configuration and security parameters already defined in
your wireless network.
Note:
All NETGEAR, Inc. 802.11g and 802.11b wireless access products use the similar
factory settings as the WGE101 and will work without any configuration changes.
The factory default settings for your WGE101 802.11g Wireless Ethernet Bridge are:
•
Mode (Infrastructure or Ad-Hoc): Infrastructure
•
Wireless network name Service Set Identification (SSID): Any
Note:
Any
means the bridge will connect to the first access point or wireless router that
responds to the bridge’s request for connection. This may not be the strongest signal or the
closest access point or router. For the WGE101 Wireless Ethernet Bridge to communicate
with a specific wireless router or access point, both devices must be configured with the
same SSID.
•
User ID: admin
•
Password: password
•
Authentication type: Auto
•
WEP security: Disabled
•
Country/Region: U.S.A.
Warning: Having the bridge set to the wrong country or region may result in the violation
of local laws.
WGE101-specific default settings:
•
IP address: 192.168.0.201
•
Protocol: Static
•
Device name: netgearnnnn (where nnnn is the last 4 digits of the MAC address)
•
Data rate: b/g combo
[any others that should be included?]
3
Содержание WGE101
Страница 1: ......
