NETGEAR WG602 V3, Руководство пользователя

Страница: 53 / 120

User’s Guide for the WG602 v3 54 Mbps Wireless Access Point
Advanced Configuration 5-5
202-10060-01, September 2004
• If using DHCP, all WG602 v3 Access Points should be set to “Obtain an IP address
automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings
menu.
• All WG602 v3 Access Points use the same SSID, Channel, WEP authentication mode, if
any, and encryption in use (WPA is not available in bridge modes).
• All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address
table.
• If MAC access control list security is enabled on the APs, verify that the MAC access
control lists on each AP are complete and accurate.
3.
Verify connectivity across the LANs.
• If you check the Enable Wireless Client Association checkbox, wireless clients will also
be able to use the AP.
• A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three LAN segments.
• If Access Control Lists are enabled on the APs, only computers in the access control list
will be able to use the AP.
Note: You can extend this multi-point bridging by adding additional WG602 v3s configured in
Point-to-Point mode for additional wireless LAN segments.