8
|
Chapter 100-240VAC PSU XCM88PS1 Installation Note
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide
Figure 2. Installing a 8800 Series 100-240VAC PSU
4.
Secure the PSU by pushing down on the locking handle until it clicks into place.
5.
If you are replacing a power supply, you do not need to unplug the AC power cord. For a
newly installed power supply, connect an appropriate AC power cord as follows:
a.
If necessary, remove the power cord retaining bracket as described in the hardware
installation guide for your switch.
b.
Connect the new AC power cord to the AC input on the front of the switch to the wall
outlet on the other end. after the cord is connected, re-install the power cord retainer.
c.
Attach the power cord retaining bracket as described in the hardware installation
guide for your switch.
Note:
Leave the ESD strap permanently connected to the switch so that it
is always available when you need to handle ESD-sensitive
components.
To install additional 8800 Series 100-240VAC PSUs, repeat steps
step 2
through
step 5
.
