NetGear Print Server Manual
38
default, the NetGear Administration Program only browses the network with NetBEUI to minimize
unnecessary packets on the network.
If you still do not see all the print servers, the print server that you are trying to configure might have
the default NetBEUI protocol disabled. If the protocol is disabled, click on the Protocol button to
enable browsing with IPX/SPX and TCP/IP. Make sure that the IPX/SPX and TCP/IP protocols are
also enabled and bound to the network adapter card in your Windows 95, Windows 98, Windows NT,
Windows XP, or Windows 2000 system.
Buttons
Advanced Button
Click on the
Advanced
button for detailed full configuration of the selected Print Server. See the later
section
5-2 Advanced Print Server Configuration
for more information about the
Advanced
option.
Quick Button
Click on the
Quick
button to open the Quick Setup Screen to perform a quick configuration of the print
server in a Microsoft network running the NetBEUI protocol.
Clicking the Quick Setup button will reveal a screen like the following.
Quick Setup Screen
Enter the required
Device Name
, and click "OK". The
Device Name
is how users on the network will
see this Print Server on the network.
Protocol Button
This screen allows you to disable protocols that are not used on your network. An example screen is
shown below.
Содержание PS100 Series
Страница 26: ...NetGear Print Server Manual 18 The next screen shows you the progress of the installation Figure 4 6...
Страница 33: ...NetGear Print Server Manual 25 Figure 4 13 Set up TCP IP for Print Server to get an IP address...
Страница 58: ...NetGear Print Server Manual 50 UL listed UL 1950 CSA certified CSA 22 2 950 TUV licensed EN 60 950 T Mark...
