NETGEAR ProSafe FWAG114, Справочное руководство, Страница: 26 / 192

Reference Manual for the ProSafe Dual Band Wireless VPN Firewall FWAG114
3-6 Connecting the FWAG114 to the Internet
Note: The FWAG114 wireless firewall incorporates Auto Uplink
TM
technology. Each
LOCAL Ethernet port will automatically sense if the cable should have a normal
connection or an uplink connection. This feature eliminates the need to worry about
crossover cables because Auto Uplink will make the right connection either type of cable.
e.
Now, turn on your computer. If software usually logs you in to your Internet connection,
do not run that software or cancel it if it starts automatically.
f.
Verify the following:
• When your turn the router on, the power light goes on.
• The router’s local lights are lit for any computers that are connected to it.
• The router’s Internet light is lit, indicating a link has been established to the cable or
DSL modem.
Note : For wireless placement and range guidelines, and wireless configuration
instructions, please see Chapter 4, “Wireless Configuration .”
2. Log in to the VPN firewall .
Note: To connect to the router, your computer needs to be configured to obtain an IP address
automatically via DHCP. If you need instructions on how to do this, please refer to
Appendix C, “Preparing Your Network .
a.
Connect to the router by typing http://192.168.0.1 in the address filed of Internet Explorer
or Netscape® Navigator.
Figure 3-4: Log in to the router
b.
For security reasons, the router has its own user name and password. When prompted,
enter
admin
for the router user name and
password
for the router password, both in lower
case letters.The router user name and password are not the same as any user name or
password you may use to log in to your Internet connection.