NETGEAR FVL328 - Cable/DSL ProSafe VPN Firewall Router, Справочное руководство

Страница: 48 / 240

Model FVL328 ProSafe High-Speed VPN Firewall v2 Reference Manual
4-8 WAN and LAN Configuration
M-10144-01
When you first configured your firewall, two implicit static routes were created. A default route
was created with your ISP as the gateway, and a second static route was created to your local
network for all 192.168.0.x addresses. With this configuration, if you attempt to access a device on
the 134.177.0.0 network, your firewall will forward your request to the ISP. The ISP forwards your
request to the company where you are employed, and the request will likely be denied by the
company’s firewall.
In this case you must define a static route, telling your firewall that 134.177.0.0 should be accessed
through the ISDN router at 192.168.0.100. The static route would look like
Figure 4-3 .
In this example:
• The Destination IP Address and IP Subnet Mask fields specify that this static route applies to
all 134.177.x.x addresses.
• The Gateway IP Address fields specifies that all traffic for these addresses should be
forwarded to the ISDN router at 192.168.0.100.
• A Metric value of 1 will work since the ISDN router is on the LAN.
This represents the number of routers between your network and the destination. This is a
direct connection so it is set to 1.
• Private is selected only as a precautionary security measure in case RIP is activated.
How to Configure Static Routes
1.
Log in to the firewall at its default LAN address of http://192.168.0.1 with its default user
name of
admin
, default password of
password
, or using whatever password and LAN address
you have chosen for the firewall.
2.
From the Main Menu of the browser interface, under Advanced, click on Static Routes to view
the Static Routes menu, shown in
Figure 4-2 .
Figure 4-2: Static Routes Table
3.
To add or edit a Static Route: