IFWA-661 Outdoor Wireless Antenna
–
Installation Guide
38 of 63
v1.0 September 20, 2019
© NetComm Wireless 2019
Note that until a selection is made using the Band Select drop down list, the antenna will not be scanning.
Once the settings are applied, the device will start scanning on the targeted band and will connect. At the
time of connection, any pending SIM OTA will occur.
Note also that if the unit was previously powered on and had gone through this page, all previous data will
still be populated, but no network connectivity will occur on this page in case any data changes.
4
Click Apply to move to the next screen.
Network scan
1
Perform an outdoor survey to identify the best install location.
The network scan screen shows for Cell Sectors entered:
Serving Cell Indicator
Minimum Allowable RSRP
Measured RSSINR
Measured RSRQ
Measured RSRP
Indicator if the Cell is acceptable
This screen generates a tone, related to the strongest signal. The installer can use the device speaker or
headphones to hear the tone.
At the top of the page, Azimuth and Downtilt of the current orientation are shown.
Figure 26 - Network scan screen
The installer has the option to proceed with the current signal results (using the Next button), try a new
location (using the Move to New Location button) or perform Advanced Operations.
To proceed with current signal results, continue to
