INSTALLATION GUIDE :
4. PRESENTATION OF THE APPLIANCES
Copyright NETASQ 2010
Page 15/66
Throughput of 200 Mbits/s.
50,000 concurrent connections.
4,000 new sessions per second.
1. Software
shutdown
button.
2. LEDs from bottom to top: Power/Status/Online.
3. Serial port: for connecting the firewall directly to a PC or modem.
4. PS2 mini-din port: for connecting a keyboard.
5. VGA port: for connecting a monitor.
6. Button to reset to the default configuration (defaultconfig).
7. 1 USB port: for secure configuration or updates.
8. OUT
Interface.
9. IN
Interface.
Point 1
: to shut down the software, hold down the software shutdown button for 4 seconds (until the
Online
(green) LED goes off).
NOTE
: There is no internal fan on this appliance.
Point 2:
the
Power
LED (yellow) indicates that the product has been plugged in. If this is the only LED that
lights up, this means that the appliance is off.
The product is running when the
Power
LED and the
Status
and
Online
LEDs (green) are visible. The
Online
LED will be the last to light up when the product is running. Traffic will pass through the interfaces.
When the appliance is starting, shutting down or being updated, only the
Status
and
Power
LEDs will light
up.
WARNING
You are strongly advised against unplugging the product when the
Status
LED is starting, shutting
down or being updated.
The
Status
LED will blink (quick blinking every 250 milliseconds) in the event of a major failure of the product
(hardware modification, faulty network interface, etc). In this case, do contact your distributor.
Points 3, 4 and 5
: these different ports enable access to the appliance in console mode.
The LEDs above the interfaces provide indications as to the throughput. For the U30, an interface with a
LED that does not light up indicates a throughput of 10 mbits/s, an interface with 2 LEDs that light up indicate
a throughput of 100 mbits/s.
1 2
3
4
5
6
7
8
9
