Starter
Irrigation-Kit
Manual
Screw the pressure reducer onto the
preassembled start connector. In order
to start irrigating, simply connect your
system to the garden hosepipe. Our
connector is suitable for all current
13 mm (1/2“) pipe and irrigation systems.
Technical requirements:
Water supply with a minium pressure of 1.5 bar., delivery pipe with fast connector. Drawing water from
other sources (e.g. rainwater) requires installation of an additional filter. In this case, contact your
professional supplier.
Lay out the dripperline as required, e.g.
along a hedgerow. The dripperline can
also be installed sub-surface (close to
the roots).
Installation:
A double row installation can be done using
the Tconnector.
When cutting the dripperline to its required
length, keep a minimum distance of at least
5 cm to the next emitter.
Close the dripperline with a line
end fitting as shown.
Content:
Hose pipe
coupling
13 mm (½“)
Screen
filter
Pressure reducer
Flat gasket
Start connector
Barb connector T
Barb connector straight
Line end
Stabilizer
50 m dripperline
(emitter spacing 30 cm)
These parts are already pre-assembled!
Start connector pre-assembled on dripperline!
2 x
4 x
3 x
20 x
Stabilizers help to keep the dripperline in
the required position.
To clean the screen filter, unscrew
the pipe coupling connector.
When reassembling ensure that
the screen filter sits in the exact
position.
Scan the QR-code with your smartphone to
watch the installation guide video.
Making the system winter-proof:
Protecting your irrigation system from frost damage requires careful
preparation. Disassemble the pressure reducer and store it in a dry location
during winter. Open the line ends and remove all residual water from the
dripperlines.
