Page 2
Requirements
Hardware Requirements
To use the Net2Phone MAX 420, you will need:
??
A Net2Phone MAX 420 unit and power cord.
??
A Local Area Network (LAN) with a broadband connection which
must
not
employ proxy server caching.
??
With FXS interfaces: a corded or cordless analog telephone, and
additional analog devices as desired for each port. Optional: a PBX,
APBX, or KPS with an analog trunk card installed.
??
A separate port on the MAX with its own telephone line connection to the
PBX, or to an analog telephone, is required for each concurrent telephone
call (or conversation) desired. For example, if capability for 3 concurrent
calls is desired, then the MAX must have at least 3 ports, each connected
to the PBX or to an analog telephone.
Additional Requirements
To configure and manage the unit, you will need:
??
An IP address, netmask, and gateway address for the MAX 420 (if your
LAN uses static addresses).
??
A Net2Phone account number and PIN (available from your reseller).
??
A PC or Mac workstation with any recent Web browser, connected to the
LAN, for initial setup and system management.
Setup Procedure
A Hardware Installation Guide that describes hardware installation, cabling, and
safety-related issues was provided along with your MAX 420 unit. Please read
that manual in its entirety
before
beginning your hardware installation. Make sure
you completely understand the issues discussed and, in particular, the safety
warnings given.
The steps in setting up your Net2Phone MAX 420 are:
1. Determine what kind of ports your unit contains and their locations (if you
do not already know).
2. Install the MAX 420 unit and connect the cabling.
3. Configure the MAX’s LAN settings so that it connects to your LAN.
4. Log in to the MAX 420 Web Manager.
5. Finish configuring the unit via the Web Manager.
6. Test your installation by making an Internet telephone call.
Net2Phone MAX 420 – Quick Start Guide
Requirements
