210-0000011 rev03
3. Connect the SDSL Line(s).
Plug the SDSL cable into the RJ21 connector for the chosen slot on the back of the IP DSLAM.
For each port being connected to a remote SDSL modem, verify that the SDSL link has been
established; the SDSL LK LED for that port will show steady illumination to indicate the
connection has been made. Link up time can vary from one to five minutes depending on the
quality, gauge and distance of the copper cables. Default bandwidth for the SAM1000-12 is 272
kbps.
SDSL RJ21 Connector Port Pinout
OVERVIEW
SAM1000-12 Management
Statistical and configuration data for the SAM1000-12 are maintained in an embedded web
server that resides within the firmware of Net to Net Technologies' Multiplexer Uplink Modules
(MUMs). This firmware contains Net to Net's Network Management System (NMS) and Simple
Network Management Protocol (SNMP).
Accessing SAM1000-12 data in a newly installed IP DSLAM
a. Connect your PC to the Ethernet RJ45 MGMT port located on the faceplate of the
MUM installed in your IP DSLAM.
b. Verify the connection; solid illumination of the MGMT LNK LED on the MUM
faceplate indicates the connection has been established.
c. Launch a web browser such as Microsoft Internet Explorer (v4.0 or higher) or
Netscape Navigator (v4.0 or higher).
d. Type the default IP address into the address field at the top of your browser and
press the Enter key.
!
192.168.254.252 if the MUM is in slot 13 (IPD12000) or slot 5 (IPD4000)
!
192.168.254.253 if the MUM is in slot 14 (IPD12000)
PORT
1
2
3
4
5
6
7
8
9
10 11 12
SDSL Tip
26 27 28 29 30 31 32 33 34 35 36 37
SDSL Ring 1
2
3
4
5
6
7
8
9
10 11 12
NOTE
Once the SAM1000-12 has been installed, bandwidth and other configurations are software selectable via Net to
Net Technologies' Network Management System (NMS). For further information regarding SAM1000-12
configuration and management please refer to the Management User Guide for IP and Mini DSLAMs.
