220-0000006 rev02
Net to Net Technologies, Inc.
112 Corporate Drive Suite 1
Pease International Tradeport
Portsmouth, NH 03801
877.638.2638 www.nettonettech.com
Connecting Cables to the IP DSLAMs
Cables used to connect copper pairs into the IP DSLAMs may be connected with the chassis powered on or off. Extra
caution should be taken when installing cables near the DC terminal blocks. Cable pin-out information is module
specific; refer to the User Manual for each module for cable pin-out information.
To install cables on the back of the IP DSLAMs, simply push the RJ-21 connector on to the connector on the back of
the chassis. Secure the cable in place using one of the provided cable ties.
Installing and Removing the Fan Tray Module
The fan tray module may be installed when the chassis is either powered on or off. Net to Net Technologies
recommends always using the fan tray when an IP DSLAM is in service.
To install the fan tray, simply guide the module into the fan tray slot and tighten the screws. To remove the fan tray,
loosen the screws and disengage the fan tray from the backplane. Allow the fan blades to come to a complete stop
before completely removing from the chassis.
Caution should be taken when removing the fan tray module. The fan blades take a few seconds to come to a
complete stop. Do not touch the fan blades until they come to a complete stop.
Need help?
If you need additional assistance with any of Net to Net Technologies’ products, please call 877-638-2638 or (603)
427-0600 for Support. We can also be reached at
.
