Installing/Changing the Bulb
To change/install the bulb, make sure the light fitting is dry, and then
unscrew the glass cover. Fit the bulb and then then replace the glass
cover, by carefully screwing it back on. Ensure that it fits tightly all
round onto the rubber washer in the base of the light fitting.
The moth trap is supplied with a 25W actinic bulb. Do not use a bulb
rated higher than 25W as this may cause overheating. Actinic bulbs
emit ultra-violet light, and we advise you not to look directly at the
bulb for long periods, as excessive exposure may cause eye problems.
Safety Precautions
For your safety this moth trap comes with a RCD plug which should be
plugged into a properly earthed mains socket. We suggest each time
the moth trap is used you carry out the following safety procedure:
1. Turn the power on at the mains socket
2. Press the RESET button to show the orange indicator, which
should then remain visible.
3. Press TEST button and the orange indicator should disappear and
the light go out. (DO NOT USE THE LIGHT IF THE ORANGE INDICA-
TOR REMAINS VISIBLE—contact a qualified electrician).
4. Press the RESET button to turn the bulb on—you’re now ready to
run the moth trap.
If you need to replace the fuse in the plug it should be replaced with
one rated at 3A.
Whilst the light fitting is waterproof, and designed for wet environ-
ments, we recommend that each time you use the moth trap you
check that the glass cover is tightly fitted onto the rubber washer .
Do not unscrew the glass cover if the fitting is wet.
