Page 2
1.0
Setting up M1XEP
1.
Before anything can be setup in the M1 AutomationBridge there is a few steps
you need to check and setup in the M1XEP (Elthernet Module).
2.
Open your M1 Account in ElkRP, and connect it to your panel via the M1XEP.
3.
Once connected, from the ‘Accounts details’ page, click on the M1XEP setup
button.
4.
Select the ‘TCP/IP Settings’ tab and ensure you have the IP address set as a static
IP address. Also ensure you have enabled the non-secure port. Keep note of
both settings as you will need this for later on. If you make any changes, press
the ‘send’ button at the bottom of the page to send the settings to the M1XEP.
