InstallatIon
2
Push lugs with a
flat screwdriver to
release keypad
To release the keypad from the base,
push the two locking lugs at the bottom
of the keypad and lift the keypad out and
away.
To fit the keypad to the base align the
top locating lugs then swing the keypad
down to lock the bottom lugs.
Accessories supplied:
1 x 4 wire loom
2 x Low profile self tapping screws
2 x Low profile machine screws
4 x Gel crimp connectors
ImPortant note
To achieve an extremely low
profile this premium keypad is
designed with close internal
tolerances.
Use only the Low Profile
screws provided. Larger
screw heads may damage
the circuit board and
invalidate your warranty.
Cable entry.
Recess cutout 47mm x 76mm
2 x mounting holes to suit single
gang wall bracket/saddle.
