The devices should be transported packaged, in containers, closed railway cars, heated and air-
tight compartments of aircraft and holds and by trucks with rain and snow protection for any
distances at temperatures from -50°C to +50°C and relative humidity of 100% at 25°C.
Average service life is 5 years min.
12.
Disposal
At the end of the service life the device is subject to disposal. The device does not pose a hazard
to human health and environment. The device does not contain any non-ferrous and precious
metals.
13.
Manufacturer’s warranty
Guaranteed storage life is 6 months from the manufacturing date (the last 6 figures in the
product serial number, for example: 191117 – November 19, 2017).
Guarantee service life is 24 months from the date of sale.
With the note of sale absent – from the manufacturing date.
Warranty obligations cease in case of non-observance of operating conditions established by
the manufacturer and mechanical damage during operation. Warranty obligations do not cover
the case of failure to present the device passport.
1 pc
1 pc
1
4
. Completeness
Executive device Radio 8113 IP65
Passport
Individual packing
1 pc
15.
Acceptance certificate
Executive device Radio 8113 IP65 (see serial number on the first page) is manufactured in
conformance with RB TR 100376351.002-2003 and essential requirements of technological
regulations, is approved by QCD and is classified as fit for operation.
16.
Potential problems
Problem
Probable reason
Fault elimination
The device does not
operate
a) t
here is no voltage;
b) t
he wires in terminals 1 and 2
are not clamped well.
a) a
pply the voltage supply
at terminals 1 and 2.
b) c
lamp the wires in the
terminals 1 and 2.
The curtain moves in an
opposite direction when it
is controlled by the
remote control button of
definite command.
The drive wires are connected
incorrectly.
To change the drive wires
connected to the terminals
4 and 5.
The
device
operates,
indicator blinks red or
green but the voltage is
not supplied on drive.
a) t
he jumper between terminals
6 and 7 is not installed;
b) t
he jumper between terminals
6 and 7 is not clamped well.
a) i
nstall
the
jumper
between terminals 6 and 7;
b) c
lamp the jumper
between terminals 6 and 7.
The device is not entered
in the programming mode
a)
l
atching switch is connected,
and the button of one of
directions is pressed.
a)
c
hange the latching
switch on the switch
without fixation;
by
pressing
the
programming button.
b) switch cable
is out of service;
c) the switch is out of service
b) c
heck/change cable;
c) c
heck/change switch.
The drive is turned on for
a short time, roller shutter
twitches and stops.
a) t
he short command mode is
installed;
b) a
short command time is
installed,
which
is
not
insufficient for the full closing of
roller shutter.
a) i
nstall the necessary
mode;
b) i
nstall the necessary
command time or reset to
factory setting.
The
device
is
not
controlled using remote
control and key switch,
red visual indicator blinks
permanently.
a) i
ncorrect operation mode of
safety inputs is installed;
b) t
here is an obstacle in area of
connected safety sensor;
c) c
able leading to the safety
sensor is impaired.
a) i
nstall the mode of safety
inputs in accordance with
the sensor or reset to
factory setting.
b)
remove an obstacle in
area of sensor;
c)
check/change the cable.
Made in the Republic of Belarus
Manufacturer:
Nero Electronics LLC
Belarus, 223016, FEZ Minsk, Minsk district,
Novy Dvor rural council, 74
tel./fax: (+375 17) 388-53-00,
[email protected],
www.neroelectronics.by
Representative office in Belarus:
Sketch LLC
220073, Minsk, 2b Skryganova str,
office 306
tel./fax: (+375 17) 317-02-32
,
Representative offices in Russia:
SketchNerogroup LLC
119361, Moscow, 15 Bolshaya Ochakovskaya Str.,
building 1
tel./ fax: (+7 495) 430-79-60, (+7 495) 735-64-47,
(+7 495) 735-66-58,
Nero SPb LLC
136070, St. Petersburg, 14 Komsomol Str., building
2
tel.: (+7 812) 987-51-56, (+7 981) 757-90-45,
Representative office in Ukraine:
Umnyye resheniya LLC
03138, Kiev, Smolnaya Str.
, 9B
tel./fax: (+38 067) 679-51-22, (+38 044) 500-18-55,
