TM200/220/260/280FN
RM200/220/260/280FN
Specification & Installation Instruction
3
ON
1 2 3 4
Rotation: CCW
Input in mA
Feedback in Vdc
Fail safe return at 90º
ON
1 2 3 4
Rotation: CW
Input in Vdc
Feedback in mA
Fail safe return at 0º
PC Board
Dip switch settings
Default Setting = All dipswitches at OFF
Stroke adjustment
–
No control signal change
1. Apply power and,
WAIT FOR LED TO BE OFF (around 10 seconds)
.
2. Press and release the reset button to start the auto-stroke process.
The LED should be illuminated.
•
First option:
The actuator will then travel in both directions to find its limit and position itself according to the demand.
The LED will extinguish, the process is complete.
•
Second option:
When the desired start position is reached, press and release the reset button. The actuator will now go the end
position. (you can also press and release the reset button when it reaches the end position)
The LED will extinguish, the process is complete.
Programming
–
Change of control signal & PWM pulse setting
1. Remove power and put all dip switches "OFF". (factory preset).
2. Apply power and,
within 10 seconds
, press and release the reset button. The LED should be blinking.
3. Select the control signal with dip switches:
Digital or Analog Modes
PWM Mode
Move switch
No1
"ON” and then “OFF”.
Digital
(On/Off or 3 point floating)
5 sec. pulse (factory preset)
Move switch
No2
"ON” and then “OFF”.
Analog
(Default)
25 sec. pulse
4.
Stroke adjustment
see the stroke adjustment section above.
Potentiometer
Dip switch
Reset button
LED
Clutch
1 2 3 4 5
TB1
ON
1 2 3 4
DS1
PB1
LD1
J
3
Microcontroller
Terminal
TB5
1 2
N L
Line voltage terminal
Pins for PWM selection
Transformer cut out
Fuse
