Page - 9
AS850 Operating Instructions
2
MACHINE OPERATION
2.1 MACHINE SETUP
2.1.1
Plug in machine, switch on at power switch and release emergency stop button.
2.1.2
Adjust the separator gap to suit the document form, as shown below.
Feed bridge
Back rests
Turn the separator adjustor until there
is sufficient gap between the separa-
tor roller and the pick-up roller below it
to allow one form only to pass
through. This is achieved by moving
the form back and forth between the
rollers until resist- ance is just felt and
the rollers lightly grip the form.
Separator
roller
Centrally place forms in the infeed tray
with the fom weight on top.Move both
side guides to leave a gap of 3mm
(1/16") either side of the form.
Note:
guides will self centre.
Infeed tray
Squareness
adjuster
Back stop
2.1.3
Establish fold type and length required, raise the top cover and set the fold
plates as described below and overleaf:
Fine adjustment knob
Lock screw
Fold plate 1
Fold plate 2
Pointer (align
inside edge
with scale)
I
SSUE
3
F
EB
2008
Form feed
weight
)
See also
following page
