ADVANCE
2
SET THE CH/Z1 AND HW/Z2 PROGRAMMING
On/Off periods
Default schedule
Two On/Off periods settings
Period 1
Start at 06:30
am
End at 08:30
am
Period 2
Start at 05:00
pm
End at 10:00
pm
Three On/Off periods settings
Period 1
Start at 06:30
am
End at 08:30
am
Period 2
Start at 12:00
pm
End at 02:00
pm
Period 3
Start at 05:00
pm
End at 10:00
pm
1-
Move the Programming slider to position
.
All days of week are solid. Underscore and Yes/
No are flashing.
4-
Press or to increment/decre-
ment the first On/Off period
end
time.
Then press Yes to confirm.
5-
Repeat for the second On/Off period
and for the third On/Off period.
(Please refer to the advanced installer
settings on Installation instruction to
enable the third On/Off period).
2-
Press
if you want to set an other
day of the week. Underscore moves
under the other days. Then press
to program the underscored day.
3-
Press or to increment/decre-
ment the first On/Off period
start
time.
Then press
to confirm.
7-
Slide the programming slider to
position to confirm and program
the second channel.
6-
The current program can be copy to
the next days. Press Yes to copy or No
to program manually the next day.
8-
Repeat the previous step to program
On/Off period for HW/Z2.
9-
When finished, move the program
slider to
position to confirm.
PROGRAMMING
Note : The unit is already set with correct date and time. Should programmer need
reseting for any reasons, please see instructions on
page 3
.
OPERATING
MODE SELECTION AND DESCRIPTION
Mode sliders sequences for CH/Z1 and HW/Z2:
Constant
all day
auto
off
Constant:
Permanent ON mode. The
system is permanently turned ON.
All day:
The system turn ON from the first
On period start time until the last Off
period end time of the current day.
Auto:
Automatic mode. The unit is control
-
ling to the programming that have been
selected
(refer to "Programming" section
page 2).
Off:
Permanent Off mode. The system stays
Off permanently. The boost mode can be
still used.
Note:
- The Programming slider must be in the
position.
- There will be a slight delay between pressing
and activation of the relay.
BOOST is cancelled by pressing again on Boost or movement of sliders.
When BOOST is running the end of Boost period is shown for each system.
BOOST
BOOST will work from any running mode.
BOOST is entered by pressing
button for corresponding system (CH/Z1 or HW/
Z2).
Press
1 time
to set
1 hour, 2 times
to set
2 hours
and
3 times
to set
3 hours
.
BOOST:
Boost mode is a temporary mode
which allows you to switch ON for 1, 2 or 3
hours. At the end of set period the device
will revert to its prior setting.
constant
all day
auto
off
constant
all day
auto
off
Advance:
advance mode is a temporary
mode which allows you to switch ON the
system in advance, until the next On/Off
period end time.
Press
button of corresponding chan
-
nel to activate this mode.
Press again
button to disable it before
the end.
constant
all day
auto
off
constant
all day
auto
off
