Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
9
Fig.2
–Scheme of pins location
3.1 Disassembling and assembling of the housing
There are logo and LEDs on the upper part of the housing.
There is a sticker with marking on the lower part of the housing.
•
The disassembling should be done as follows:
1. Place the housing on a solid surface in such a way the logo to be upwards
2. Insert a card into the gap at the angle of 45 degrees until the housing starts splitting
Do not split two parts of the housing at this stage.
3. Insert a card into the gap from the other side of the housing at the angle of 45 degrees until
the housing starts splitting.
4. Take off the lower part of the housing
5. Bending two latches of any side of the housing, lift the scheme up and gently remove it
without damaging the wires and the built-in battery.
•
The assembling should be done in the reverse order:
1. Make sure the wires of the battery are not squeezed and then install the scheme.
2. Pressing to the scheme alternately from both the sides, clamp the scheme holders
3. Install the upper part of the housing.
4 Installation
It is strongly recommended to carry out a preliminary check of the tracker before installation,
using a power supply different from the vehicle on-board power, with an output voltage from 8 V to
40 V DC and current of at least 1 A.
