NEO TOOLS 90-070, Перевод оригинальной инструкции

Страница: 6 / 45

3.3.1 Left Knob: selector with heat setting
the device is turned off
the fan runs at low power
the fan is running at full power
the heating element works at half power
the heating element is working at full power)
3.3.2 Right Knob: Thermostat dial
3.3.3 P ower light:
Above is the power indicator light
3.3.4 W ork indicating lamp: Below is the work indicator light
4. Introduction:
4.1 Depending on the power cord type this fan heater may be used only in household , warehouses and workshops,It incorporates a Adjustable trip
thermostat and a self-resetting thermal cut-out to control the heating elements. The thermostat feels the air temperature and controls the surrounding
temperature.The fan motor is not controlled by thermostat and it keeps on working when the thermostat cuts off the heating element.The self-resetting
thermal cut-out will switch off the heater to ensure the safety when overheating.
4.2 When using the heater for the first time, you may notice a slight emission of smoke. This is quite normal and it stops after a short time. The
heating element is made of stainless steel and was coated with protection oil by production. The smoke is caused by the left oil when heated.
5. Using Instructions:
5. 1The machine is equipped with a Adjustable trip thermostat, which automatically shuts down when the machine is not in an upright position (falling
back and forth).When it is moved to an upright position, the device will return to normal operation.Always keep the machine upright before starting
5. 2Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet environments and flammable objects.
5. 3 Connect the fan heater to the mains.
5. 4 Set the Adjustable trip thermostat knob to the MAX and let the heater operate with full power.
5. 5 The fan heater will switch on when the heating selector is set to one of the power settings.
5. 6 Once the room reaches the required temperature, heating element will stop working but fan also working .Once the temperature decreased, the
heating element will be working. The fan heater now starts and stops automatically and thus keeps the room temperature constant.
5. 7 Before switch off the heater, please turn the thermostat to MIN position and turn the switch to fan position, let the appliance cool down for two
minutes then turn off the heater and pull out the plug.
6. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the
problem before calling the service centre.
Problem Possible cause Treatment
The heater does not operate, even
when it is plugged in and the switch
thermostat are switched on .
The plug is loose, bad connection
Pull out the plug, check the connection of the plug and
socket. Then connect again.
No power in socket outlet Insert the plug in a proper socket
The heating element glowing
The input voltage is too high or too low Use power supply according to the rating on the label
The air inlet grill is blocked
Keep the heater far way from articles like curtain,
plastic bag, paper and other things which can cover
the inlet or can be easily cover on the air inlet
The appliance didn’t heat up, or
only ventilator worked
The switch was not put at heating setting Turn the switch to heat setting
The thermostat operated
Turn the thermostat and listen if there is open/close
voice. If there is no click and the thermostat is not
damaged, the heater will automatic switch on when
the appliance cooled down
The self-resetting cut-out operated
Turn the heater off and inspect the blockage of inlet or
outlet. Disconnect the plug and wait at least 10
minutes for the protection system to reset before
attempting to restart the heater.
Abnormal noise The appliance is not stands upright Put the heater on a level surface
7.Cleaning and Maintenance
：