NEO TOOLS 75-202, Инструкция по эксплуатации

Страница: 13 / 56

neo-tools.com
13
HOW TO MAKE A SINGLE MEASUREMENT
Use the ON switch (2) to switch the device on, it automatically sets to single
measurement mode. Press the ON button (2) to make single measurement.
HOW TO MAKE CONTINUOUS MEASUREMENT
Use the ON switch (2) to switch the device on, it automatically sets to single
measurement mode. Press and hold the ON button (2) for approximately 3 seconds
to make continuous measurement. The device will be showing measured values
constantly. Press the ON button (2) shortly to store the result of the continuous
measurement and the device will switch to the single measurement mode.
HOW TO MEASURE AREA
The area measurement mode is used to measure rectangular areas. Use the ON
button (2) to switch on the device, then press the UNITS button (3) to switch on the
area measurement mode. Press the ON button (2) to measure one of the sides of a
rectangle. Make the measurement of the second rectangle side in the same way.
The result shown is the rectangle area.
HOW TO MEASURE VOLUME
The volume measurement mode is used to measure rectangular cuboid volumes.
Press the ON button (2) to switch on the device, then press the UNITS button
(3) twice to switch on the area measurement mode. Press the ON button (2) to
measure one of the cuboid edges. Make the measurement of the other two cuboid
edges in the same way The result shown is the rectangular cuboid volume.
PROBLEMS AND TROUBLESHOOTING
The device displays errors using error codes. The table below shows code
descriptions and solutions.
Error code Cause Solution
204 Calculation error Repeat the measurement
accordingly to the manual
208 Too high current Contact the manufacturer
220 Depleted battery Replace batteries
252 Too high temperature Let the device cool down to
temperature below 40°C
253 Too low temperature Warm up the device to temperature
above 0°C
255
Too weak
measurement
signal/too long
measurement time
Use aim board or make
measurements using surface that
reflects light
256
Too strong
measurement signal
Use aim board or make
measurement on less illuminated
surface
261 Beyond
measurement range
Choose measurement point in the
measurement range