Neo Instruments VENTILATOR II, Руководство пользователя, Страница: 20 / 32

20
II. CONNECTIONS AND SETTINGS
VENTILATOR II comes with a stereo input and a stereo output.
The Lo / Hi switch matches input gain to the signal source. You
can insert VENTILATOR II between your instrument and amp
or mixing console as well as into an FX loop.
IN L, IN R / MONO
This jacks accept stereo organ, keyboard, and guitar signals.
However for the rotary effect only the IN R / MONO jack is
used. Connect mono instruments here. In Bypass mode both
jacks are routed to the outputs in stereo.
LO / HI
This switch adjusts input gain. The Lo position works for most
organs, keyboards, and guitars. Only very low-output guitars
and keyboards require you to switch over to Hi. The output
signal is automatically compensated to ensure a constant level
at both settings. The Overload LED serves as a level meter.
Overload LED
This LED lights up to indicate the input or output signal level
has reached the circuit’s threshold. For the best possible
signal-to-noise ratio and AD converter resolution, turn up the
input signal until the LED just begins lighting up at signal
peaks. Then back the input signal off again until the LED no
longer lights up. That’s the optimum level for this device.
OUT L, OUT R / MONO
VENTILATOR II provides a stereo output. If you connect the
device to a mixing console, turn the mixer’s panorama knobs to
the far left and right to achieve a realistic-sounding spatial
effect. If you need just a mono signal – say, in an elaborate
composite mix or when using a stage monitor or guitar amp –
tap it by plugging into the R/MONO output only.