Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This
procedure should only be used when the primary controller is inoperable.
1. Remove the cover of PIR sensor.
2. Make sure the sensor is powered.
3. Press and hold the reset button for 10-15 seconds, then LED lights would flash red color 1
time first, then 5 times on and off alternately.
4. Release the code button.
Safety Warning for Batteries
The product contains batteries. Please remove the batteries when the device is not used. Do
not mix batteries of different charging level or different brands.
Installation
Holder Installation
Fix the holder with screws and screw stopper or put the sticker on the bottom of motion
sensor then fix it on the wall.
Battery Installation
1.Make sure PIR placed within the Z-Wave network range of gateway.
2.PIR is recommended to be fixed at the height of 2- 4 meters off the ground.
3.When install PIR, please keep it far away from places where air temperature changes
sensitively, e.g., around air conditioners, refrigerators, stoves and so on.
4.Furniture, large bonsai or other spacers shouldn’t be placed within PIR’s detection area.
5.When installing PIR, please keep it away from stairs, elevators and other obstructions. Make
sure these obstructions are outside of PIR’s detection area.
6.After instaling PIR, please test whether PIR works properly or not, if there is false alarm
from PIR, please install PIR in another place.