V E H I C L E I N S T A L L A T I O N
6
Audi
Make sure you have your radio’s theft protection code before you attempt installation.
When you reconnect power to the battery, you will need to enter this code.
Information about the theft protection code can be found in your vehicle’s audio
operation manual.
Before connecting any cables to the black box you must set the dip switch to the Audi
position. If you set the dip-switches after you have connected cables to the box, you
must disconnect and reconnect them for the changer to operate.
§
All Models (1998-2004) –
Pre-wired 13-pin CD changer cable in the left-rear
trunk of all Audi vehicles.
§
Audi A8 (2003-2004) –
Not Compatible.
§
Audi A6 (2004) –
Not Compatible.
Once you connect the Neo Changer, turn on your radio. A CD icon will appear on
the display of your radio showing that the Neo Changer is ready to use.
This step
may take up to three minutes.
Switch to the Neo Changer by pressing the CD/ Mode button on the radio.
Audi has a direct access disc system, to select a disc enter the number into the
keypad; Press button number “3” for disc number 3 in the magazine. See your
vehicle’s audio operation manual for detailed information.
To change tracks simply press “
Seek <
” or “
Seek >
”
INSTALLATION WARNING
Initial use of the changer can take
up to three minutes
. The radio must check the
magazine in the changer
*Due to the direct access disc system, you will not be able to directly access
discs 7-10. To access these discs you will have to go to the last track on disc 6
and let it play until it loads disc #7. ( you can fast forward the track, but you
must let it play the last 5 seconds of the track, for it to change to disc # 7
S E T T I N G S
F O R A L L
A U D I S
1
2
3
4
5
6
7
8
ON
OFF
OFF
OFF
OFF
OFF
ON
OFF
O P E R A T I O N
