I N S T A L L A T I O N P R E P A R A T I O N
2
First Step (For All Vehicles)
The first and most important step in using the Neo Changer is setting the dip-switches
on the black box; this makes the changer compatible with the vehicle it is being
installed in. The Neo Changer
will not work
if this step is not followed correctly.
The dip switches can be found on the side of the black plastic box which connects to
the changer. Switches are in the
“ON”
position when they are switched
down
. Black
box settings for each vehicle can be found on the vehicles installation page. Refer to
the index to find the page number within this manual that covers your vehicle.
Position of anti-vibration mechanism
Once the installation location has been selected the position of the built in anti-
vibration mechanism must be set. If the mechanism is not set correctly discs will skip.
To set the changers position the anti-vibration must be set the same on both the left
and right sides of the changer.
To install the changer in a horizontal position (Magazine door facing forward) the anti-
vibration mechanism must be set to “0”.
§
Horizontal (Magazine door forward) –
Set to “0” (as pictured above).
§
Vertical (Magazine door up) –
Set to “90”.
§
45° (Magazine door at an angle) –
Set to “45”.
S W I T C H
P O S I T I O N
