Focus the projection by turning the lens in and out until the
desired sharpness has been achieved. Beware that you don't take the lens that far
turns out that it comes loose and falls out of the projector. This can cause damage
and/or cause injury.
12. Maintenance
Always turn off the projector after use, carefully remove the plug and let the projector cool before
moving or storage it.
The lens should only be cleaned with a soft cloth, making sure that the fans remain dust-free.
Use a soft tissue or lens cloth with a
little spirit or pure alcohol to clean the lens.
Do not try to open the projector yourself and never touch the LED module
–
you can cause damage!
In case of problems, take the projector to a qualified technician (Nenko can advise you on this)
To replace the fuse, turn off the device and let it cool down sufficiently. Then you can replace the
fuse with a fuse with the same specifications: t1AH/250V Ceramic 20 mm x 5mm diameter) The fuse
can be found in the IEC panel on the back. Remove the fusesholder using a flat screwdriver. Reinse
the fuseholderand press until it nolonger protrudes. Ifthe fuse breaks down immediately, contact
Nenko, do not use a fuse with higher values.
For more information you can visit our website
www.Nenko.com.
