Mount the projector using the bracket in one of the following ways:
Adjust the angle and position of the projector using the
button that connects the bracket to the projector. Unscrew the knob,
place the projector in the desired position and tighten the knob again.
To adjust the position of the lever, press the central button,
pull the lever away from the projector, turn it to the desired
point and release.
Electric connection
Make sure that plug and cord are not trapped. Make sure you can't trip over
the loose cable.
When using an extension cable, it must meet at least the same technical
specifications as the projector. Cords with a lower amperage can cause
overload.
Insert the round end of the 12V transformer into the 12V contact
on the back of the projector.
Turn on/Off
Place the wheel motor with liquid or effect wheel in the port at the rear of the projector.
Plug it in. Turn the projector on or off with the on/off button with symbols "O" for off and "I" for on.
Place & turn on accessories
Slide a suitable wheel motor into the guides of the rear gate
(The impact or liquid wheel belongs in the southeast guide) The wheel motor
does it immediately as soon as it is placed.
Make sure that the
ventilation openings
ALWAYS remain free
when installing them!
WARNING:
Never use this
projector lying down
with the bottom on a
flat surface, or while
the ventilation opening
is blocked!
