2
Due to continuing improvements, actual product may differ slightly from the product
described here in. Tools required for assembly and service may not included.
SPECIFICATIONS
Glue Gun: 220V-240V~50Hz
40W
Crossbar Adjustment: 3” min to 5” max
UNPACKING
When unpacking, make sure that the item is intact and undamaged.
Check that no parts are missing.
IMPORTANT SAFETY INFORMATION
1. Always wear approved safety goggles and heavy duty work gloves during use.
2. Contains glue; keep away from children. This product is not a toy, do not allow
children to play with or go near this item.
3. Use as intended only.
4. Inspect before every use; do not use if parts are loose or damaged.
5. Maintain product label and name-plates. These carry important safety
information.
6. Always store is a safe, secure place.
7. Keep these instructions for future use.
INSTRUCTIONS
Please read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein before set
up or use of this product.
1. Insert Glue Stick (2) into Glue Gun (1). Plug in Glue Gun and allow to warm up
for then to fifteen minutes before use.
2. Using clean cloth (not include), clean dent area with Release Agent (3). Then
apply heated glue from Glue Gun to end of desired Pull Tab (4).
3. Place Pull Tab on centre of dent and hold there for ten seconds. WARNING! Do
not push Pull Tab against dent.
4. Place cross bar (5) over Pull Tab, setting Adjusters (9) to desired length.
Thread Wing Nut (6) onto end of Pull Tab. Continue to twist Wing Nut until dent
is raised. Stop when dent returns to a normal surface level.
5. Unthread Wing Nut and remove Cross Bar and Pull Tab from surface. Apply
two drops of Release Agent to spot of dried glue. Use Scraper to peel off
softened glue patch.
6. If a high spot has been created, use a hammer (not include) and lightly tap
Dowel (8) against raised spot until desired smoothness is reached.
7. Note: The Dent Master repair kit will not repair all kinds of dents, regardless of
