Neilsen CT5721, Оригинальное руководство пользователя

Страница: 7 / 16

(presumably) been dropped or are broken, have chipped fragments, are cracked
or are otherwise damaged. Before use, check that the cutting disc has been
correctly mounted and tightened. Start the unloaded tool for 1 minute in a safe
position. Stop it immediately if excessive vibration or other faults are observed,
then investigate the cause of the fault. Prevent the spindle tip from touching the
bottom of the bowls, cones or pivots with threaded holes intended for attachment
to machine spindles by checking their size and other data. If adapters or
reducing sleeves are supplied with the cutting disc, the user must ensure that the
adapter or the sleeve does not come into contact with the face of the fixing flange
and that the fixing forces are sufficient to prevent the disc from slipping during
rotation. If the fixing flanges are supplied in several types or sizes, always match
the correct flange(s) to the cutting disc used. Avoid direct contact with the
inserted tool during and right after work, as it can be hot or sharp. Store and
handle the cutting disc with care taken in accordance with the manufacturer’s
instructions.
Hazards connected with the workplace
Slips, stumbles and falls are the main causes of injury. Beware of slippery
surfaces caused by using the tool, as well as tripping hazards caused by the air
system. Handle with care in an unfamiliar environment. There may be hidden
hazards, such as electricity or other utility lines. The air tool is not intended for
use in potentially explosive zones and is not insulated from contact with
electricity. Make sure that there are no electric cables, gas pipes, etc. which
could pose a risk in the case of damage with the tool.
Personal safety
Wear personal protective equipment.Dust, noise, vibration and swarf can all be
dangerous if not suitably protected against. If the work involving the power tool
creates dust or fumes; wear a dust mask. Vibration to the hand, caused by
operating some tools for longer periods must be protected against. Wear
vibration reducing gloves and allow long breaks between uses. Protect against
dust and swarf by wearing approved safety goggles or a face shield. These are
some of the more common hazards and preventions; however, always find out
what hazards are associated with the machine/work process and wear the most
suitable protective equipment available.