4
5. ASSEMBLY
1. Insert a foot into the slot in the standing block . Align the holes in the two
components and join them together using an M12 x 25 bolt . Note that the
standing block has a threaded hole on one side and a clearance hole on the
other.
2. Place a large washer over the upstanding rod on the standing block and insert
the rod through the slot in the main support guide from underneath. Place a large
washer over the thread on top of the rod and secure the assembly to the main
support guide by screwing on a Look Nut. Assemble the other foot/standing block
and fix the assembly to the other end of the main guide beam in the same way.
3. Drop a large washer over an adjustable screw and screw a grip handle onto
the top of the adjustable screw. Screw the grip handle approximately half way
down the threads. Make up the second adjustable screw in the same way and
have both assemblies ready to drop through the slot in the main guide beam after
the beam has been placed over the engine bay.
4. The chains should also be attached when the guide beam is mounted over
the engine.
