Neilsen CT2279, Оригинальное руководство пользователя

Страница: 8 / 12

7
after the air supply is disconnected.
Note: Air flow, and therefore Air Angle Die Grinder performance, can be
hindered by undersized air supply components.
3. The air hose must be long enough to reach the work area with enough
extra length to allow free movement while working.
4. Release the Throttle. Close the in-line shutoff valve between the
compressor and the tool.
5. Turn on the air compressor according to the manufacturer’s directions and
allow it to build up pressure until it cycles off.
6. Adjust the air compressor’s output regulator so that the air output is enough
to properly power the tool, but the output will not exceed the tool’s
maximum air pressure at any time. Adjust the pressure gradually, while
checking the air output gauge to set the right pressure range.
7. Inspect the air connections for leaks. Repair any leaks found.
8. If the tool will not be used at this time, turn off and detach the air supply,
safely discharge any residual air pressure, and release the throttle to
prevent accidental operation.
OPERATING INSTRUCTIONS
Read the entire Important Safety Information section at the beginning
of this manual including all text under subheadings therein before set
up or use of this product. Inspect tool before use, looking for damaged,
loose, or missing parts. If any problems are found, do not use tool until
repaired.
Tool Set Up
WARNING! To prevent serious injury from accidental operation: Turn off the tool,
detach the air supply, safely discharge any residual air pressure in the tool, and
release the throttle and/or turn the switch to its off position before performing any set
up, inspection, maintenance, or cleaning procedures.
To prevent serious injury: Do not adjust or tamper with any control or component in
away not specifically explained within this manual. Improper adjustment can result in
tool failure or other serious hazards.
Installing an Accessory
1. Use the Wrench to hold the Spindle in place while, at the same time,
loosen the Collet Cap.
2. Slide the accessory (sold separately) into the Collet opening. The