Neilsen CT1085, Оригинальное руководство пользователя

Страница: 9 / 12

8
parts. If any problems are found, do not use tool until repaired.
Tool Set Up
To prevent serious injury from accidental operation, Detach the air
supply, safely discharge any residual air pressure in the tool, before
installing bits or making any adjustments to the die grinder.
Specific Operating Instructions
1. Add a few drops of Pneumatic Tool Oil inside the air inlet before every use.
2. Note: Air Angle Die Grinder is designed to be used with grinding
attachments, and sanding discs and other attachments.
3. Use the Wrench to loosen the Collet and Collet Nut .
4. Insert 1/4” diameter shank of a Grinding Accessory (not included) fully into
Collet Nut. Then, firmly re-tighten Collet Nut to lock both the Collet and
Grinding Accessory in place.
5. Connect air supply hose to Air Inlet. Turn on air compressor and set its
regulator to the maximum 90 PSI for Die Grinder.
6. WARNING! Grip the Die Grinder firmly with both hands.
7. Slowly apply hand pressure to the Control Lever until the desired speed is
obtained.
NOTE:
The Die Grinder always turns the Accessory clockwise (reference:
while holding the tool as you would when operating it). Always point abrasive
material away from you.
8. With a firm grip on the Die Grinder, lightly apply accessory to workpiece,
slowly and steadily moving tool to right and left until achieving desired
appearance (finish) on workpiece.
9. If Air Angle Die Grinder requires more force to accomplish task, verify that it
receives sufficient, unobstructed airflow (CFM) and increase pressure (PSI)
output of regulator up to maximum air pressure rating of tool.
10. If the tool still does not have sufficient force at maximum pressure and
sufficient airflow, then a larger tool may be required.
11. CAUTION! To prevent tool and accessory failure, resulting in injury: Do
not exceed the tool’s maximum air pressure rating of 90 PSI.
12.Once work is completed, release hand pressure on Control Lever.
13. Turn off air compressor. Slowly squeeze Control Lever to release any
remaining air pressure from Die Grinder. Then disconnect air hose.
14. Remove Accessory from Die Grinder. Store the tool in a clean and dry
location out of the reach of children