5
day or after every two hours of use. This must be done directly along the male coupler or
oil inlet provided for the purpose on the side of the tool’s housing.
Automatic lubrication is also possible using a mini oiler that you have to install between
the tool and the compressor. Make sure that the oiler is always filled with suitable oil.
1.
Tool 6. Quick coupler
2.
Quick connector 7. Lubricator
3.
Quick coupler 8. Regulator (0-8.5 bar)
4.
Air hose 9. Filter
5.
Quick connector 10. Air compressor
4. OPERATION-AIR IMPACT WRENCH
WARNING!
Ensure that you read, understand and apply the safety instructions
before use.
4.1. Only use impact sockets, which are specifically designed for use with an impact wrench.
4.2. Connect the wrench to the air hose as in Section 3.
4.3. Fit the socket onto the square drive and then place the socket over the subject nut.
Squeeze the trigger to operate the wrench.
4.4. To change direction push the button at the top of the handle, direction “F” for forward and
“R” for reverse.
4.5. The flow of air may be regulated by adjusting flow valve at the base of the handle.
DO NOT
use any additional force upon the wrench in order to tighten or remove a nut.
DO NOT
allow wrench to free run for an extended period of time as this will shorten the life
of its bearings.
Take care not to over-tighten fixings.
5. OPERATION-AIR RATCHET WRENCH
WARNING!
Ensure that you read, understand and apply the safety instructions
before use.
