Neilsen CT0700, Инструкция по эксплуатации

Страница: 11 / 16

Hammer action for drilling masonry
Inserting drill bit see (fig 3) when using a
masonry drill for impact drilling hammer
action, turn the large dial on the top of the
drill to the left to the hammer and drill symbol
see (fig 6) and turn the large dial at
the back of the drill in front of the trigger on/of
switch to the left, to the drill and hammer
symbol
see (fig 7)
Fig 6 Fig 7
For normal drilling into wood and metal
Remove the 13mm chuck from the carry case
and insert the chuck as (fig 3) to use this
chuck which can take drills from 1.5 to 13mm
shank. Tighten the chuck by hand making
sure that the drill is located between the three
lugs in the chuck, which hold the drill to be
used, then tighten the drill with the key, insert
the key into one of the holes in the chuck and
seat into the cog this will allow you to tighten
the chuck to the drill. Do not use
unnecessary force, as it may be difficult to
undo.
Do not insert drill bit into chuck and
tighten as shown in Fig. 8. Drill bit MUST
be properly inserted with all three chuck
jaws holding the bit centered in the chuck.
Failure to properly insert drill bit could
cause the drill bit to be thrown from the
chuck resulting in possible serious injury
or damage to the chuck.
Fig 8
To use the drill for wood and metal
Insert the drill into the chuck and tighten and
turn the large dial on top of the drill to the left
hammer and drill symbol
see
(fig 6) and turn the large dial at the back of
the drill in front of the trigger on/off switch to
the right to the drill symbol
see (fig 9)
Fig 9
If using a masonry drill with the chuck in
place see figure 6 and 7. hammer action for
masonry.
Variable speed dial
The variable speed dial 300 to 800rpm is
located at the bottom back left side of handle
set the dial to the preferred speed and then
squeeze the trigger. See (fig 10)
Fig 10
This rotary hammer drill does not have
reverse direction, so always take care not
to force the drill in case the drill bit gets
stuck. Always make sure you keep the
drill going in and out to remove debris to
make sure the drill does not get stuck.
This drill does not have torque facility. It
is not recommended to use screwdriver
bits in this drill as it could damage the
screwdriver head or bit and could cause
serious injury
11
WARNING !
WARNING !
ASSEMBLY & OPERATION