Neilsen CT0700, Инструкция по эксплуатации

Страница: 10 / 16

Always make sure the power tool is
isolated from the power supply before
fitting any attachment
Moving the handle. See (Fig 1)
To move the handle to any position that suits
the job in hand, grab hold of the handle and
rotate it to the left and it will come undone it
can then be moved to the required position,
when in the position re-tighten by rotating to
the right. Always make sure the handle is
tight before any job takes place as a loose
handle could cause you to slip and invite
injuries.
Turn left Turn right
Fig 1
Switching the drill on/off
The drill has an On/Off switch (Fig 2) built in
to the handle. Holding the drill with both
hands simply squeeze the trigger and the
motor will start. To switch off release the
trigger.
Trigger
switch
Fig 2
WARNING
The rotary hammer drill continues for a few
second after the trigger has been release, so
be careful when putting it down.
Fitting a drill bit, chisel bit and keyed
chuck into the SDS housing.
The bits have slots in the shank; these locate
with tabs in the drill. Grip and pull back the
black shrouding see (Fig 3) and insert the bit
you want to use, push the bit inwards until a
resistance is felt, it may be necessary to spin
the bit until the shaft drops completely in to
place. Once you are satisfied the bit has
seated, release the black shroud, this should
lock the bit into place.
Note
The bit will be gripped firmly by its shank and
will not be able to be removed, if the bit is not
located and can be removed, you must
repeat the procedure until it is lock in place.
Do not use the drill until you are satisfied
the bit is secured.
To remove the bit pull back the shroud and
the bit can be removed.
Fig 3
Impact chisel only.
Place chisel in the shroud as (fig 3) locate the
dial on the top of the drill and rotate it until
the large hammer symbol
aligns with
the arrow on the drill casing see (fig 4) locate
the large lever to the rear of the drill in front
of the on/off trigger switch See (fig 5) turn the
selector to the drill hammer symbol.
Fig 4 Fig 5
ASSEMBLY & OPERATION
10
WARNING
!
← →