Neilsen CT0698, Оригинальное руководство пользователя

Страница: 9 / 12

8
Note: Air flow, and therefore Air Angle Die Grinder performance, can be
hindered by undersized air supply components.
a. The air hose must be long enough to reach the work area with enough
extra length to allow free movement while working.
b. Make sure tool’s Control Lever is in the off position; refer to Operation
section for description of controls.
c. Close the in-line safety valve between the compressor and the tool.
d. Turn on the air compressor according to the manufacturer’s directions
and allow it to build up pressure until it cycles off.
e. Adjust the air compressor’s output regulator so that the air output is
enough to properly power the tool, but the output will not exceed the
tool’s maximum air pressure at any time. Adjust the pressure gradually,
while checking the air output gauge to set the right pressure range.
f. Inspect the air connections for leaks. Repair any leaks found.
g. If the tool will not be used at this time, turn off and detach the air supply,
safely discharge any residual air pressure, and release the throttle and/or
turn the switch to its off position to prevent accidental operation.
11.Operating Instructions
Read the entire Important Safety Information section at the
beginning of this manual including all text under subheadings
therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, or missing
parts. If any problems are found, do not use tool until repaired.
Tool Set Up
To prevent serious injury from accidental operation, Detach the air
supply, safely discharge any residual air pressure in the tool, before
installing bits or making any adjustments to the die grinder.
Specific Operating Instructions
1. Add a few drops of Pneumatic Tool Oil inside the air inlet before every
use.
2. Note: Air Angle Die Grinder is designed to be used with grinding
attachments, and sanding discs and other attachments.
3. Use the Wrench to loosen the Collet and Collet Nut .