Home Connect
en
35
The appliance automatically tries to connect to the
app and the setting
•’ƒ
is displayed. The value
‚
flashes in the control panel.
6.
Start the app on the mobile device and follow the
instructions for manual network registration.
The registration procedure has been completed once
the
‹
value appears on the cooking position display.
Home Connect settings
You can adjust Home Connect to suit your
requirements at any time.
In the basic settings for your hob, navigate to the Home
Connect settings to display network and appliance
information.
Notes
■
The
•’ƒ
setting is only displayed if the appliance is
connected to the home network.
■
The
•’„
setting is only displayed if the appliance
has once connected to a network.
■
The
•’†
setting is only displayed if an update is
available.
■
The
•’‡
setting is only displayed if Customer
Service is attempting to connect to the appliance.
You can end this at any time after granting access.
■
The
•’ˆ
and
•’‰
settings are only displayed if
there is a connection to WLAN.
Deactivating Wi-Fi
If Wi-Fi has been activated, you can use the Home
Connect functions.
Note:
In networked standby mode, your appliance requires a
maximum of 2 W.
1.
Switch on the hob.
2.
Touch and hold the
.
symbol for 3 seconds.
The product information is displayed.
3.
Touch the
.
symbol repeatedly until the
•’„
setting appears.
‚
lights up on the cooking position display.
4.
Set the value to
‹
using the twist knob.
This deactivates Wi-Fi; the
D
symbol will go out on the
control panel.
Symbol
Function
•’‚
Registration in the home network (WLAN)
‹
Not connected /disconnect network.
‚
Connect automatically.
ƒ
Connect manually.
„
Connected.
•’ƒ
Connection to app
‹
Not connected.
‚
Connect.
•’„
Connect to WLAN
‹
Radio module switched off.
‚
Radio module switched on.
•’…
Settings via app
‹
Switched off.
‚
Switched on.*
•’†
Software update
‚
Update available and ready for installation.
ƒ
Starting installation.
•’‡
Remote access by Customer Service
‹
Not permitted.
‚
Permitted.
* Basic setting
•’ˆ
WLAN signal strength
‹
Not connected to home network (WLAN).
‚
Signal strength 1 (poor)
ƒ
Signal strength 2 (moderate)
„
Signal strength 3 (good)
•’‰
Connection to Home Connect server
‹
Not connected.
‚
Connected.
Symbol
Function
* Basic setting