en
TwistPad®
10
7 TwistPad®
The TwistPad® control is a pull-out rotary knob which
can be used to select the cooking zones and power
levels. As it is magnetic, it automatically centres itself in
its special programming zone.
7.1 Positioning and operating the
TwistPad®
Position the rotary knob so that it is centred on the pro-
gramming zone in relation to the displays that limit this
zone.
To switch on a cooking zone, touch TwistPad® at the
level of the required cooking zone. Turn the rotary knob
to select the power level.
Note:
The rotary knob still functions correctly even if
the knob is not precisely centred.
Always keep the rotary knob clean. Soiling may impair
its function.
7.2 Instructions for use
¡
A strong magnet is located inside the rotary knob.
Keep the rotary knob away from magnetic data car-
riers such as credit cards and cards with magnetic
strips. It may damage them. The magnet may also
cause faults on televisions and screens.
¡
The rotary knob is magnetic. Metal particles stuck to
the bottom may scratch the surface of the hob. Al-
ways clean the twist knob thoroughly.
7.3 Removing TwistPad®
You can remove the rotary knob from the cooking zone
during the cooking process.
If you remove the controller, Wipe protection is
switched on for 35 seconds. If the rotary knob is not re-
turned to its position before this time elapses, the hob
switches off.
WARNING ‒ Risk of fire!
The hob may continue to heat up. If, during this 35
seconds, a metallic object is placed in the area of the
TwistPad, the hob may continue to heat up.
▶
Always switch off the hob at the main switch.
7.4 Operation without rotary knob
TwistPad®
You can also operate the hob without TwistPad®:
1.
Switch on the hob using the main switch.
2.
Within the next 5 seconds, simultaneously press
and hold and for 4 seconds. An audible signal
sounds.
3.
Press repeatedly until the display for the required
hob lights up.
4.
Then set the required power level using or
.
a
The cooking zone is switched on.
Notes
¡
You cannot switch on the timer without the rotary
knob.
¡
You can always position the rotary knob in the pro-
gramming zone again.
8 Before using for the first time
Observe the following recommendations.
8.1 Preparing the appliance
To ensure correct operation, you must arrange the
components in this order:
1.
Insert the filter.
2.
Insert the metal grease filter.
Note:
Never operate the appliance without the metal
grease filter and the overflow container.
8.2 Setting the operating mode
The appliance is supplied with a preset circulating-air
mode.
When your hob is installed with an air outlet to the out-
side, you must configure the setting to this mode.
You can find additional information about this in the
section entitled
→
9 Basic operation
9.1 Switching on the hob
▶
Touch .
The symbols for the cooking zones and the cur-
rently available functions light up. light up next to
the cooking zones. Set the rotary knob TwistPad®
to the setting range.
a
The hob is ready for use.
ReStart
▶
If you switch the appliance on within four seconds of
switching it off, the hob operates with the settings
that were previously set.
9.2 Switching the hob off
▶
Touch until the displays go out.
a
All cooking zones are switched off.
