en
16
Timer programming *
* depending on model
You can delay the start of the programme
by 3, 6 or 9 hours.
Switch on ON/OFF switch
1
.
Keep pressing the Preselected starting
time button
2
until the appropriate
display 3 h, 6 h or 9 h is lit.
Press Start button
9
.
The preselected starting time
is activated.
To delete the preselected starting time,
keep pressing the Preselected starting
time button
2
until none of the
displays 3 h, 6 h or 9 h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the End
display
8
is lit.
The end of the programme is also
indicated by an acoustic signal.
The buzzer volume can be set in 4 stages.
Accordingly 0, 1, 2 or 3 displays are lit.
(see water hardness table).
Factory setting: 2.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
1
.
Hold down button >
6
and press
Start button
9
until the End display
8
and salt refill indicator
11
flash.
Release buttons.
Keep pressing button >
6
until the
salt refill indicator
11
and rinse aid
refill indicator
10
flash.
Release buttons.
The refill indicator
11
flashes and
the displays
10
and A are B lit
(= setting 2). The set buzzer volume
can be heard.
Change the setting as follows:
ress button <
5
until the required
setting has been selected.
Press Start button
9
.
The displays go out.
The selected setting is saved.
Close the door.
Switching off the appliance
Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door.
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
1
again.
Close the door.
