Installation instructions
en
17
9.3 Inserting the hob into the wider cut-out
1.
Create the wooden battens in accordance with the
drawing.
2.
Check and adjust the cut-out dimensions.
3.
Screw the wooden battens in place so that they are
flush with the upper edge of the worktop. For stone
work surfaces, bond the wooden battens in place.
9.4 Installing fixing rails
For stone work surfaces, bond the fixing rails in place.
¡
The hob can also be installed in an existing cut-out
that has a depth of 500 mm.
9.5 Connecting the hob
Requirement:
The cooker must be connected to the
mains, but switched off.
1.
Screw the
PE
conductor (green/yellow) for the hob
to the cooker's earthing point .
2.
Plug the hotplate plug into the cooker.
The colour of the cable should match the colour
shown on the label.
9.6 Installing the hob
Ensure that the cables are not trapped or pinched, and
do not route them over sharp edges.
¡
Push the hob in until it locks into place.
9.7 Removing the hob
1.
Disconnect the appliance from the power supply.
2.
Slide the cooker out and place it in front of the unit
(and on a pedestal, if required).
3.
Unplug the hotplate plug.
4.
Finally, disconnect the
PE
conductor (green/yellow)
from the earthing screw.
5.
Push out the hob from below.
Содержание M16SRF Series
