NEFF D64 Series, Руководство пользователя и инструкции по установке

Страница: 16 / 20

en
Installation instructions
16
7.
Screw in the safety screw with the washer.
Piping
Note:
If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend the piping with an exhaust air pipe dia-
meter of 150 mm.
Establishing the exhaust air connection (exhaust
pipe, 150 mm diameter)
1. Secure the exhaust pipe to the air pipe connector.
2. Establish the connection to the exhaust air opening.
3. Seal the joints.
Establishing the exhaust air connection (exhaust
pipe, 120 mm diameter)
1.
Secure the reducing connector to the air-pipe con-
nector.
2.
Secure the exhaust air pipe to the reducing con-
nector.
3.
Seal the joints.
Installing the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
1. Screw the retaining bracket for the flue duct to the
wall.
2. To separate the flue ducts, remove the adhesive
tape or the flue duct from the protective packaging.
3. Remove any protective foil from both flue ducts.
4. Note:
The slots on the flue duct should point down-
wards.
Push one flue duct section into the other.
5. Note: To prevent scratches, lay soft towels over the
edges of the outer flue duct to protect the surface.
Place the flue duct sections on the appliance.
6.
Slide the inner flue duct section upwards, and at-
tach it to the left- and right-hand sides of the retain-
ing bracket.
7. Engage the flue duct section downwards.
8.
Screw the flue duct section to the sides of the re-
taining bracket using two screws.
9.
Use two screws to secure the outer flue duct sec-
tion to the appliance from below.
10.
Carefully remove the towels.