NEFF B 15P42.0 GB, Инструкция по эксплуатации, Страница: 22 / 28

22
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
1.
Insert the panel diagonally towards the back (fig. A).
2.
Stick the retaining clips onto the right and left-hand sides of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
3.
Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
4.
Put the cover back in place and screw it on.
5.
Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
ã=
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Malfunction table
% $
$ %
D
D
& '
Problem Possible cause Note/remedy
Electrical operation is faulty (e.g. indicator
lamps no longer light up).
Circuit breaker faulty. Check fuses in the fuse box and replace if
necessary.
Liquid or thin batter runs to one side. Appliance not installed level. Check appliance installation (see the Installation
instructions).
Appliance no longer works,
‹
:
‹‹
flashes
in the clock display.
There was a power cut. Reset the time of day (see section: Electronic
clock).
‹ : ‹‹ flashes on the clock display,
“rrr”appears on the temperature display.
The power supply was interrupted
while the appliance was in
operation.
Press the clock function button, reset the time of
day (see section: Electronic clock).
“E011” appears in the temperature
display.
Permanent assignment of a
button.
Cancel the permanent assignment of the button
and press the clock function button.
The temperature display shows, EXXX,
e.g. E300.
Internal fault in the appliance
electronics.
Press the clock function button. If the message
does not go out, pull out the mains plug and plug it
back in again after approx. 10 seconds.
Appliance operation is not possible, D
and -
†
-appear in the temperature display.
The appliance controls have been
locked.
Deactivate lock (see section: Childproof lock).