BOOSTERS
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO
Page 10 of 16
3.3 PROGRAM THE CONFIGURATION CARD
3.3.1
USING THE PHILIPS PEGODA PROGRAMMER
3.3.1.1 REQUIREMENTS
This requires a Philips Pegoda Mifare programmer to be connected to a USB port on
your computer. In the ‘Pegoda’ menu of the configuration software click ‘Connect’ to
connect to the programmer.
Once the connection has been established and all configuration settings are entered,
place an empty Mifare Classic 1K or 4K transponder card on the Pegoda unit.
3.3.1.2 PROGRAMMING
To program the configuration into the Mifare card click ‘Write configuration into card’ in the ‘Pegoda’
menu. The message ‘Configuration written into mifare card’ should appear to indicate that the
programming action was successful.
The software will warn you with the message ‘Overwrite configuration card’ if there is already a
configuration on the Mifare card. Click ‘Yes’ to proceed and overwrite the configuration on the card or
click ‘No’ to abort.
3.3.1.3 READ
BACK
It is also possible to read back what configuration is programmed into a configuration card. Click ‘Read
configuration from card’ in the ‘Pegoda’ menu to do that.